For my 1/8-scale Trans Am build, I need a set of four snowflake wheels reproduced in resin. I’ll supply sharp photographs and dimensioned sketches of the original Pontiac rim, so you can work directly from those references without redesigning anything. What I need you to do is translate those images into production-ready wheels at the correct scale and deliver them in resin. I’m open to either receiving the four finished prints or, if it’s simpler for you, a clean, test-sliced STL or STEP file that I can run on my own resin printer. Whichever route we choose, final wheels must show crisp detail—center cap, lug holes, and that signature lattice pattern—while matching the real wheel’s diameter, width, and backspacing when scaled down. Before full delivery, please send photos of a first print for a quick fit and detail check. Once approved, ship or send the complete set (along with your recommended resin settings if we go the file route). These wheels should arrive ready for light sanding, primer, and paint—no warping, bubbles, or loss of edge sharpness. That’s the entire scope. Let’s bring this iconic snowflake design to life in miniature.