Mechanical Design: V-Belt and Pulley Transmission System (AutoCAD) Project Description: I am looking for a skilled Mechanical Drafter or Engineer to develop a complete technical drawing for a V-belt transmission system using AutoCAD. Technical Specifications: 1. Quadruple V-Belt Pulley: Outside diameter of 240 mm with four grooves. 2. Smaller Pulley: Outside diameter of 120 mm. 3. Transmission Layout: Center-to-center distance between shafts is 275 mm. 4. Modeling Requirements: Full 2D/3D modeling of both pulleys and the belt assembly. Hub dimensions are provided and should be applied to both components. Non-standard data may be estimated according to mechanical design best practices. Deliverables (Required on a single standard 'A' size sheet): • Isometric Perspective: A clear 3D view of the entire transmission system. • Orthographic Views: Properly dimensioned views of the assembly. • Cross-Section View: At least one longitudinal section showing the internal geometry of the pulleys and the belt seating. • Data Table: A standardized technical table containing pulley specifications and the selected belt type. • Title Block: All information must be contained within a standard course title block (details/template will be provided). Requirements: • Expertise in AutoCAD (Mechanical). • Solid understanding of technical drawing standards (ISO/ABNT). • Precision in dimensioning and mechanical tolerances. Note: I will provide the reference diagrams and specific hub dimensions upon hiring