I’m ready to cut a design into two cabinet doors on my Shaper Origin and I need the SVG laid out accurately before I start. Each door is finished at 18" × 27" and will be milled from solid wood. I’ll send you a clear reference photo so you can match the exact design and also a simple file for the door pulls. The material will be 3/4" and router bit would be Rounded-Shoulder Juice Groove Router Bit, 1/2'' Dia. x 3/16''H x 1/4'' Shank Here’s what I’m expecting: • One clean, correctly-sized SVG (or Shaper-ready design file) with separate layers or line colors for outside cut, inside pocketing (if any), and on-line reference marks and a separate file for the door pulls. • Geometry that imports into Shaper Origin at true scale—no need for additional resizing or unit conversion. • File checked for open nodes or duplicate paths so the Origin recognizes every cut as intended. If you have experience preparing woodworking vectors for the Shaper workspace, this should be straightforward. Once delivered, I’ll confirm the file loads correctly and the toolpaths look good; after that the job is complete.