I have a site drawing that must clear the SmartDCR / eNaksha scrutiny engine used by the Punjab Urban Development Authority (PUDA). The file currently throws the classic “Layers not formatted” error. I will share both the problem DWG and a fully approved sample so you can see the standard I need duplicated. Your task is to open the existing DWG, correct every layer name, colour, line-type and block attribute so that it aligns perfectly with the SmartDCR layer table. Once done, run the drawing through the PreDCR or eNaksha validator to confirm there are zero layer-formatting faults and no other compliance issues. The final file must load into the PUDA portal and pass without a single warning. Because timing is critical, I need this turnaround fast—ideally within 24 hours of receiving the files. Deliverables • Cleaned DWG that passes the SmartDCR/PUDA checker with zero errors • Brief validation report or screenshot showing the “Approved” status Acceptance Criteria The job is complete only when the drawing is accepted by the PUDA scrutiny engine with no red flags. If you have already worked on SmartDCR, PreDCR or eNaksha submissions, send me one relevant example and let’s get started immediately.